ES serise high-speed intermittent slot die coating head, gun service block has an independent filter block that can be installed in multiple directions connect hose inlet, the coating gun each module is opened and closed by air pressure snuff back module, Springs are used to keep needles closed when no air pressure is supplied to the head, each ES high-speed module is installed above the coating head and the coating lip is installed on the lower of the head to directly control the intermittent coating. The service block heater between module provided an average heating and compatible Pt100 / Ni120 accurate sensors temperaute control.

Overview:

Clean pattern start and cutoff

opened and closed by air pressure snuff back module Improved response time

Accurate and consistent hot melt adhesive cutoff pattern

ES series are offered in 85mm-1000mm coating wide configurations

Module design positions solenid valve directly on/off improved performace

Pt100 or Ni120 temperature sensor available

Buit-in replaceable large filter